RMILEC high-precision PWM/PPM/SBus Signal Converter V2
PWM PPM SBUS signal conversion
Mode 1 PWM Input :Converts the input PWM signal into a corresponding PPM signal and SBUS PPM signal output.
Mode 2 PPM Input: Converts the input PPM signal into a corresponding PWM signal and SBUS signal output.
Mode 3 SBUS Input:Converts the input SBUS signal into a corresponding PPM signal and PWM signal output.
PWM port support 1-18CH input and 18CH output.
PPM port support 1-18CH input and 5-18CH output.
SBUS port support 18CH input and 18CH output.
If the CH quantity of output signal more than the CH quantity of input signal,converter will populate useless CH with 1.5MS data.
Under SBUS input mode,PPM port only has 10CH output.(PPM signal of more than 10CH has too large delay,so it’s useless)
After power up,the converter will wait 10 or more signal cycles to determine the input signal is stable,if there is no signal input then the LED will blink slowly .
while the converter working normally, if the input signal is lost then the output is automatically filled up with 1.5mS data,and the LEDs blink rapidly.
Press and hold the button then power up , three LED flashes several times later release the button,then enter the setting mode. Press the button , PWM - PPM - SBUS cycle selected , the corresponding LED lights up to indicate. Setting data are automatically saved. Cycle power to use .
Input voltage :3.3-12V
Support Reverse battery protection ( protect the converter but does not protect the servo )
Accuracy :4000count per 1 ms (10PPM source )
Signal Generator: Hardware not interrupt program