Found 4 results for "eclipse" under the categories below:

Mini-Quad HQ
Mini Quad FramesMini Quad ARFs
Flash Deals
Sorted:
  • ZMR Eclipse 210mm ARF for Advanced Users

    Brief Setup Guide of ZMR EclipseZMR Eclipse is a new 210mm carbon fiber mini quadcopter that designed based on the hot selling ZMR-X210. We are always listenting to what our customers say and made some slight changes to make it a better racing frame. For your easy setup, also considering on different users might have different requirements on the setups, we have prepared three different ARF packages of ZMR Eclipse for different levels of users, including:ZMR Eclipse ARF for FPV BeginnersZMR Eclipse ARF for Intermediate UsersZMR EClipse ARF for Advanced UsersThese are the ARF packages of ZMR Eclipse that specially prepared for serious advanced users. You are choosing these because you are very strict with the performance of your racing quads. To meet your expectations, we use Betaflight F4 AIO flight controller, one of the most reputable FCs in FPV community, on the builds. Better performance and easy to setup. Easy wiring, no need to use an extra PDB.In order to have a better compatible with Betaflight F4, we have changed to use Betaflight 35A 32bit BLHeli ESC. These ESCs have a soldering along the edges to allow more power going through. No need to worry about how much power you will give to them during flying.As to FPV camera, we use a better professional FPV camera, the RunCam Eagle 2. It is probably one of the best FPV cameras out there in terms of image quality and WDR capability. It has a clearer and better image, allowing the pilot to clearly obeserve the tiny objects even flying through a complex area, very suitable to use it for FPV racing.For the propellers, we have changed to use DalProp 5040. Many top pilots use these propellers for FPV racing! In general, comparing to the ARF packages for beginners and intermediates, the ARF packages for advanced users use the best flight controllers, ESCs, FPV camera and propellers to ensure the best performance. Furthermore, the weight have been saved a lot, the installation has been simplified.ARF 1 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit  * 1 setDragonfly Hurricane 2207 KV2500 Brushless Motor * 4 pcsBetaflight 32Bit 35A 2-6S BLHeli_32 ESC Dshot1200 * 4 pcsBetaflightF4 Flight Controller * 1 pcDALPROP Q5040 4-Leaf Props * 8 pairsAccessories Bag * 1 setARF 2 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit * 1 set RunCam Swift 2 1/3 CCD IR Blocked Micro Camera * 1 pcDragonfly Hurricane 2207 KV2500 Brushless Motor * 4 pcsBetaflight 32Bit 35A 2-6S BLHeli_32 ESC Dshot1200 * 4 pcsBetaflightF4 Flight Controller * 1 pcDragonfly 5.8G 48CH Stackable Video Transmitter * 1 pcDragonfly Transmitting Extension Cables * 1 pcDragonfly Booster 5.8G FPV Antenna 5cm SMA * 1 pcDALPROP Q5040 4-Leaf Props * 8 pairsAccessories Bag * 1 setARF1 Including:ARF2 Including:

    $179.99-$249.99

    SKU:ZMARF4

    Weight: 0.50 kg

  • ZMR Eclipse 210mm ARF for Intermediate Users

    Brief Setup Guide of ZMR EclipseZMR Eclipse is a new 210mm carbon fiber mini quadcopter that designed based on the hot selling ZMR-X210. We are always listenting to what our customers say and made some slight changes to make it a better racing frame. For your easy setup, also considering on different users might have different requirements on the setups, we have prepared three different ARF packages of ZMR Eclipse for different levels of users, including:ZMR Eclipse ARF for FPV BeginnersZMR Eclipse ARF for Intermediate UsersZMR EClipse ARF for Advanced UsersCongratulations. You are now no longer an FPV newbie!!! Since that the ARF packages for beginners can not meet your requirements any more, you need a better setup. And these intermediate ARF packages are just made for you!We have made these ARF packages with a more powerful setting and comes with a better FPV image. The frist step, we have changed the motors to Dragonfly Hurricane 2207 2500kv motors. More powerful and faster respond speed. To match the motors, we have changed the ESCs to Robotdog as well. Robotdog is a 35A 32bit BLHeli_32 ESC, it supports Dshot1200 to ensure you a smooth flying.Considering the speed is now greatly improved, you have a higher requirement for the camera images. So we have changed the FPV camera to Runcam Swift 2. It is a professional FPV camera even no need to worry about backlight during flying.With the these setup, now you can try to join your local FPV community and race with other pilots. Maybe you are the next FPV champion.ARF 1 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit  * 1 setDragonfly Hurricane 2207 KV2500 Brushless Motor * 4 pcsRobotdog 35A 32Bit 2-4S BLHeli_32 ESC Dshot1200 * 4 pcsMATEK PDB XT60 with BEC * 1 pcOmnibus F4 V5 Flight Controller * 1 pcDYS 5040 4-Leaf Propeller CW+CCW 1 Pair * 4 pairsAccessories Bag * 1 setARF 2 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit * 1 set RunCam Swift 2 1/3 CCD IR Blocked Micro Camera * 1 pcRunCam RC25G FPV Lens 2.5mm * 1 pcDragonfly Hurricane 2207 KV2500 Brushless Motor * 4 pcsRobotdog 35A 32Bit 2-4S BLHeli_32 ESC Dshot1200 * 4 pcsMATEK PDB XT60 with BEC * 1pcOmnibus F4 V5 Flight Controller * 1 pcDragonfly 5.8G 48CH Stackable Video Transmitter * 1 pcDragonfly Transmitting Extension Cables * 1 pcDragonfly Booster 5.8G FPV Antenna 5cm SMA * 1 pcDYS 5040 4-Leaf Propeller CW+CCW 1 Pair * 4 pairsAccessories Bag * 1 setARF1 Including: ARF2 Including: 

    $149.99-$199.99

    SKU:ZMARF2

    Weight: 0.50 kg

  • ZMR Eclipse 210mm ARF for FPV Beginners

    Brief Setup Guide of ZMR EclipseZMR Eclipse is a new 210mm carbon fiber mini quadcopter that designed based on the hot selling ZMR-X210. We are always listenting to what our customers say and made some slight changes to make it a better racing frame. For your easy setup, also considering on different users might have different requirements on the setups, we have prepared three different ARF packages of ZMR Eclipse for different levels of users, including:ZMR Eclipse ARF for FPV BeginnersZMR Eclipse ARF for Intermediate UsersZMR EClipse ARF for Advanced UsersThese are the ARF packages of ZMR Eclipse for FPV beginners. We built these aiming to provide you a durable setup with an extremely low cost. It can satisfy your daily practice like freestyle flying. If you are new to FPV, these are definitely perfect choices for you. These ARF packges for FPV beginners come with the reputable Omnibus F4 flight controllers, RJX 2205 2300kv brushless motors and Cyclone BLHeli_S 20A ESCs. We have tested all the parts to make sure they are matching well to have a good performance. The included Omnibus F4 flight controller is not just for beginners, but it is also greatly used in some advanced settings for professional pilots. The omnibus series of flight controllers are known to be the best all in one integrated flight controller, using the best selection of sensors and parts at a great price and small form factor. It uses the MPU6000/ICM-20608 IMU over SPI for the super fast gyro updates (up to 32Khz) to keep up with the fast F4 MCU, allowing you to run your betaflight/iNav control loop insanely fast.  This gives you the extra edge when racing your FPV quadcopter.The Dragonfly 5.8g stackable VTX comes with 48 channels, 9-26v input and switchable between 25/200/600mw. The stackable design makes you easy to place this VTX above your flight controller. With 48 channels, no need to worry about the interference while powered on any more. We choose Cyclone BLHeli-s to use on the builds. BLHeli-S is still the most stable firmware. We have tested the ESCs, it is powerful enough to run with the included RJX 2205 2300KV motors.The ARF packages come with both 2 blades propellers and 3 blades propellers. The 2 blades props save more power than the 3 blades so that you can fly for a longer time, very suitable for FPV beginners. When you are good at flying, you can change to use the 3 blades propellers.The builds also comes with 700TVL 5-12V Micro FPV Camera to make you can enjoy the FPV racing. In general, these setups are specially made for FPV beginners with a good performance and low cost. They can be flied with full throttle and used for freestyle flying, very suitable for practice.ARF 1 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit  * 1 setRJX 2205 2300KV Brushless Motors * 4 pcsCYCLONE BLHELI-S 20A ESC * 4 pcsMATEK PDB XT60 with BEC * 1 pcOmnibus F4 V5 Flight Controller * 1 pcDragonFly 5030 Bulletproof Props White * 2 pairs5030 Inch Electric Propeller White * 2 pairsAccessories Bag * 1 setARF 2 Including:ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit * 1 700TVL 5-12V Micro FPV Camera * 1RJX 2205 2300KV Brushless Motors * 4 pcsCYCLONE BLHELI-S 20A ESC * 4 pcsMATEK PDB XT60 with BEC * 1pcOmnibus F4 V5 Flight Controller * 1 pcDragonfly 5.8G 48CH Stackable Video Transmitter * 1 pcDragonfly Transmitting Extension Cables * 1 pcDragonfly Booster 5.8G FPV Antenna 5cm SMA * 1 pcDragonFly 5030 Bulletproof Props White * 2 pairs5030 Inch Electric Propeller White * 2 pairsAccessories Bag * 1 setARF1 Including: ARF2 Including: 

    $110.99-$149.99

    SKU:ZMARF

    Weight: 0.50 kg

  • ZMR Eclipse 210mm Carbon Fiber Mini FPV Quadcopter Frame Kit

    ZMR-X210 is one of the most popular and reputable racing frames of FPV Model. We are always listening to what our customers say, and now here comes a new version - ZMR Eclipse. We have made some slight changes to the ZMR-X210. The new body frame is a bit shorter and remove some unnecessary parts but keep the wheelbase the same as 210mm. Still use the same 3K carbon fiber material that we use on ZMR-X210 and ZMR210R. The weight is about 122 grams only including the hardwares.Ajdustable camera angle design, two kinds of installation methods, suitable for the most common FPV cameras on the market.Another big improvement is that the nuts have already been pressed into the carbon plates, so that it is more convenient to build and also will save some weight.Use countersunk screws on the top plate, it is more stable for the battery to put on it. And there remains two battery strap locations to secure the battery. The distance is more reasonable than the x210.3.5mm bottom plate, the ZMR Eclipse is able to survive from the hardest crashes. The installation for the 4 nylon standoffs is more reasonable comparing to the ZMR-X210.Package included: 1x ZMR ECLIPSE Carbon Fiber Frame4x 4mm Carbon Fiber Arms 1X camera mount1x Board Camera Mount 1x Set of Steel screws, aluminum mounting hardware, and standoffs 2x FPVModel velco strap1x 2mm top plate 2x 3.5mm lower platesWeight: 122 grams (Frame and hardware totally ) We have made some slight changes to the ZMR-X210. The new body frame is a bit shorter and remove some unnecessary parts but keep the wheelbase the same as 210mm. Still use the same 3K carbon fiber material that we use on ZMR-X210 and ZMR210R. The weight is about 122 grams only including the hardwares.Ajdustable camera angle design, two kinds of installation methods, suitable for the most common FPV cameras on the market.Use countersunk screws on the top plate, it is more stable for the battery to put on it. And there remains two battery strap locations to secure the battery. The distance is more reasonable than the x210.Another big improvement is that the nuts have already been pressed into the carbon plates, so that it is more convenient to build and also will save some weight.3.5mm bottom plate, the ZMR Eclipse is able to survive from the hardest crashes. The installation for the 4 nylon standoffs is more reasonable comparing to the ZMR-X210.

    $39.99-$25.99

    SKU:ZMREF

    Weight: 0.50 kg

Find us on Google+ Watch us on Youtube Like us on Twitter Follow us on Facebook

Home   |   About Us   |   New Products   |   Multi-Rotors   |   FPV Airplanes   |   FPV Equipment   |   Battery / Chargers   |   Tools & Accessories   |   Contact Us   |   Blog   |  Site Map

Product Tags: ABCDEFGHIJKLMNOPQRSTUVWXYZ0-9

Copyright © 2015 FPVMODEL.COM®. All Rights Reserved.